 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
Water intake radiator hose and fan belt were previously removed
as well as the lower water hose and heater line. As to the magnetic
fan switch wire (N° 57)described in the doc ? I'm not sure this
was correctly in place. |
 |
One of the square head screws is missing. Rotors are unmounted
by removing the three nuts. |
 |
The pump is removed by removing the five fixation screws and
pulling or tapping the pump out. |
 |
 |
Quick cleaning still shows rusted fan blades. |
 |
I noticed that I still had not replaced a pedestal I had stolen
last year, so before I get to the rear axle. I might as well
start with the gas tank. First off is the black plastic cover. |
 |
Wire to the gas gauge is disconnected. |
 |
Once the plastic cover is off the rubber elbow connecting
the tank to the fill orifice and the two retention rings are
visible. |
 |
The orifice has been mounted using wood screws ! Ugly work... |
 |
The tank itself is mounted with quite a mix of screws (2 10mm,
a 12mm, one hex head) Proof of a previous (mediocre) restore
work... |
 |
Supports and the various screws are a bit rusty. |
 |
 |
 |
Gas goes in here (notice the wood screws)... |
 |
...and out here. |
